Forcepoint V10000 G3 Quick Start Manual

Quick Start Guide
Forcepoint V10000 G3
Web or Email Protection Appliance
Before you begin...
Plan your deployment before setting up the appliance. See the
back of this guide for a deployment overview and reference sheet.
1 Verify Contents
Accessory Kit
1
Power Cables (2) Ethernet Cables (4)
Bezel (faceplate)
2 Sliding Ready Rail Kit
• Left Ready Rail
• Right Ready Rail
• Velcro Straps (2)
• Rack Installation Instructions
Cable Management Arm Kit
3
• Cable Management Arm • Cable Tie Wraps
• Static Support Tray • CMA Installation Instructions
• Status Indicator Cable
Contact Forcepoint Technical Support if any items are missing.
Rack Appliance
2
See the Rack Installation Instructions included in the
Sliding Ready Rail kit.
©2016 Forcepoint LLC. All rights reserved.
3 Determine Security Mode
The appliance supports the following security modes:
• Web (TRITON AP-WEB)
• Email (TRITON AP-EMAIL)
Based on your subscription and deployment plan, determine the appropriate security mode for this
appliance.
Connect Network Cables
4
Connect the appliance interfaces required by the security mode for this appliance. Cat 5E cables (or
better) are required. Do not use crossover network cables.
Serial Cable
5 Connect Input Device
1. Connect to the appliance via serial port or KVM in order to access the command line interface for
initial configuration. Serial port settings are: 9600 baud, 8 bits, no parity.
Serial Connection
1 1
2. Secure power cables using velcro straps and plug power
cables into an appropriate power source.
KVM Connection
2 2
Power On Appliance
6
Power on the appliance and check the following indicators:
Front
• Power button is illuminated.
• Hard drive LEDs are green.
Rear
• Power supply LEDs are green.
• LEDs for connected interfaces (NICs) are green.
• System status indicator (LED left of power supplies) is solid
blue.
Contact Forcepoint Technical Support if any indicators are not
illuminated correctly.
7 Configuration Overview
Please refer to the TRITON Appliances Getting Started guide for
more details.
Initial Configuration
Firstboot Script
• Configure security mode.
• Configure Appliance Controller interface (C).
• Configure NTP servers/system time.
Appliance Command Line
• Configure applicable network interfaces.
• Configure other settings as desired.
Web Mode
TRITON Manager
• Enter subscription key, update Master Database, configure
Network Agent, and configure policies in TRITON Manager.
• Requires Windows Server 2008 R2 or Windows Server 2012
or 2012 R2.
Content Gateway Manager (proxy)
• Configure user authentication and select protocols.
Email Mode
TRITON Manager
• Complete configuration wizard, enter subscription key, and
configure policies in the Email module. Configure email DLP
policies in the Data module.
• Requires Windows Server 2008 R2 or Windows Server 2012
or 2012 R2.
QSG420-100_RevF