Mira Element Thermostatic Mixer Installation And User Manual page 34

Inlet Filters
the inlet Filters should be checked and cleaned as necessary every 12 months.
note! the inlet Filters must not be removed except for cleaning. if the thermostatic
Mixer is operated without the Inlet Filters fitted the Warranty on the product will be
void.
exposed Models
1. isolate the hot and cold water supplies and operate the control lever to drain
any residual water.
2. carefully remove the Filter Blanking caps and unscrew the Filter caps with
the 'o Key' (supplied) or a 12 mm hexagonal wrench and remove the Filters.
3. Clean the filters under a jet of water to remove any lodged particles.
4.
Refit the Filters and tighten the Filter Caps.
note! Make sure that the 'O' seal is fitted correctly and not damaged.
5. turn on the hot and cold water supplies and check for leaks.
6. Refit the Filter Blanking Caps.
Filter cap
Filter Blanking
cap
Filter
'o' seal
34