Mira Element Thermostatic Mixer Installation And User Manual page 20

1.7 Fit the securing Brackets to the Mixer
with the Bracket securing screws.
Important! Make sure that the
correct holes are used, otherwise the
Backplate cannot be fitted.
note! the securing Brackets can be
rotated for suitable fixing points.
1.8 Make sure that the Mixer is level and
mark the positions for the countersunk
fixing holes on the wall.
1.9 For solid walls drill two 6 mm holes
for the Wall Plugs.
Caution! Do not drill into pipes in the
wall.
1.10 Fit the Wall Plugs (supplied) and fix
the Mixer to the wall with the screws
provided.
note! For stud partition installations
alternative fixings may be required
(not supplied).
1.11 connect the hot and cold supply
pipes and tighten the compression
nuts.
Caution! Make sure that the olives
are fitted and all pipework is flushed
through before connecting to the
Mixer.
1.12 connect the outlet pipework, leaving
enough pipe through the wall to
temporarily cap off (refer to your
shower Fittings installation and User
Guide).
1.13 turn on the water supplies and check
for leaks.
countersunk Fixing hole
Backplate
securing hole
note! securing Brackets shown
in preferred position to allow the
compression nuts to be tightened.
hot supply
20
rotate for suitable
Fixing Point
Backplate
securing hole
outlet Pipe to Fittings
screws
cold supply