Mira Element Thermostatic Mixer Installation And User Manual page 21

1.14 attach the Building-in shroud to the
Mixer using the two shroud screws
removed earlier.
1.15 Using the 'Finished Wall indicator'
on the Building-in shroud as a guide,
finish the wall, e.g. tiles.
Caution! Make sure that the finished
wall is within the maximum and
minimum limits and to an even depth
(no greater than 2 mm variation) or
the control components will not fit
correctly.
1.16 remove the two shroud screws
(retain for later use) and remove the
Building-in shroud.
1.17 Fit the shower Fittings, refer to your
shower Fittings installation and User
Guide for instructions.
note! For high pressure systems,
a 12 litre/minute flow regulator
(supplied) can be fitted under the
hose washer.
1.18 Fit the concealing Plate and control
assembly, refer to section: 'Control
Assembly'.
Minimum finished
wall surface
Maximum finished
wall surface
21
Finished Wall F9802
Min
Max