Upload; Config Ipif System - D-Link Web Smart DES-1210-28P Reference Manual

6 Command Line Interface
firmware_fromTFTP
cfg_fromTFTP
tftp://ip-address/
filename

Upload

The upload command is used to upload the firmware file or a Switch configuration file to a TFTP
server.
Syntax
upload {
tftp://ip-address/filename }
Parameters
Parameter
firmware_toTFTP
cfg_toTFTP
tftp://ip-address/
filename

Config ipif system

The config ipif system command sets the IP address of the switch.
Syntax
config ipif system { ipaddress <ip-address> <subnet-mask> gateway <gw-
address> | dhcp }
Parameter
Parameter
ipaddress
address> <subnet-
mask>
gateway
address>
dhcp
Example
DES-1210-28P> config ipif system ipaddress 172.17.5.214 255.255.255.0
gateway 172.17.5.214
% The IP setting mode change to static will cause CLI disconnect.
Download and install new firmware on the Switch from a TFTP server.
Download a switch configuration file from a TFTP server.
The IP address of the TFTP server.
The filename of the firmware or switch configuration file on the TFTP
server. You need to specify the DOS path if the file is not at the root
directory of the TFTP server.
Note: Switch will reboot after restore and
all current configurations will be lost
firmware_toTFTP
Description
Upload the firmware on the Switch from a TFTP server.
Specifies that the Switch's current settings will be uploaded to the TFTP
server.
The IP address of the TFTP server.
The filename of the firmware or switch configuration file on the TFTP
server. You need to specify the DOS path if the file is not at the root
directory of the TFTP server.
Description
<ip- The IP address and subnet mask to be created. Users need to specify
the address and mask information using the traditional format (for
example,10.1.2.3/255.0.0.0).
<gw- The IP address of the router or gateway.
Allows the selection of the DHCP protocol for the assignment of an IP
address to the Switch's System IP interface.
Figure 117 – The config ipif system command
D-Link Web Smart Switch User Manual
tftp://ip-address/filename
70
| cfg_toTFTP