Table of Contents
Advertisement
3) Turn on the Bluetooth transmitter and make it enter paring mode. It will
search for Bluetooth devices automatically and send a pairing request;
4) When the headset requests to enter a PIN No., the transmitter will
response "0000" automatically;
5) After successful pairing and connecting, blue LED of the headset flashes
twice every 4 seconds and emits "connected"
Remarks:
The pairing password of BTH033L is "0000". So, the headset can only
pair with a Bluetooth transmitter whose pairing password is "0000".
If pairing still fails after several tries, please refer to the Bluetooth
transmitter's user's manual for further information.
3）Pairing headset with multi devices via Bluetooth
The headset can connect with two Bluetooth cell phones at the same time.
The general pairing procedures are as follows:
1) Pairing the headset with device one
2) Turn on the headset and make it enter pairing mode again, and pairing it
with device two
3) Operate device one to connect with headset. The headset has already
connected with two devices in this moment . Restart the headset, it will
also connected with two devices automatically.
Remarks:
The multi-pair function is off in factory set, please turn on this function as
following:
Turn on: long press
and
connected device), and release it until you hear four raise tone
Turn off: long press
and
connected device), and release it until you hear four raise ton
To improve the stabilization of headset, we suggest you turn off the
multi-pair function when you only connect with one cell phone.
4. Battery display
When the headset connected with IOS device, it will display the battery of
the headset on the device. When the headset is in low battery, power symbol
show red, it emits you to charge for your headset.
5
button under standby mode(not
button under standby mode(not
Advertisement
Table of Contents
