Color Flow Mode (Cfm) Controls - GE Medical Systems LOGIQ 400 Quick Start Manual

Color Flow Mode (CFM) Controls

There are four Soft-Menu pages for Color Flow Mode imaging adjustments.
CFM 1/4
CFM Slant Diag MTI
Map Scan Mode Filter
VT–1 + MAP LOW
CFM 2/4
Frame Penet High Display
Average Resoltn Thrshld
MID
t
LOGIQ 400 Quick Start Guide
2237879–100 Rev. 0
CFM Map—Allows for the selection of how Doppler velocities are mapped as
color over the gray scale.
Slant Scan—Used to control the position of the CFM window for linear
probes only.
Diag Mode—Allows for the selection of the best color flow display format.
MTI Filter—Filters out low flow velocity color.
Frame Average—Averages color information from previous frames with the
current frame.
Capture
Penet—Penetration can be increased by lowering the operating frequency of
the active probe.
32 OFF
High Resoltn—Provides a quick way to maximize resolution for the CFM
display.
Display Thrshld—Gray scale level at which the overlay of color information
stops.
Capture—Displays the highest mean velocity (average velocity) detected
over a specific time interval.
Quick Start 17