Starting An Exam; Patient Entry Menu - GE Medical Systems LOGIQ 400 Quick Start Manual

Starting an Exam

Patient Entry Menu

Press the New Patient key at the beginning
of each study to reset the system and enter
new patient data. When the New Patient key
is pressed, the Patient Entry menu appears.
Ensure that the Blue Shift key is not active.
Use the Trackball to move the highlight cursor to the Exam
Category Selection line. Enter the desired exam number and fill in
the appropriate patient data.
Highlight EXIT and press Return or press New Patient again when
the patient entry menu data has been completed.
The system takes a few seconds to load new exam category
parameters and calibrate the attached transducers before entering
the scan mode.
t
LOGIQ 400 Quick Start Guide
2237879–100 Rev. 0
Quick Start 9