Table of Contents
Advertisement
Using the projector in standby mode
Some of the projector functions are available in standby mode (plugged in but not turned
on). To use these functions, be sure you have turned on the corresponding menus under
POWER MANAGEMENT > Standby Settings, and the cable connections are correctly
made. For the connection methods, see the
Active Audio Out
Selecting On outputs an audio signal when the AUDIO IN socket is correctly connected to
a proper device.
Adjusting the sound
The sound adjustments made as below will have an effect on the projector speaker. Be sure
you have made a correct connection to the projector audio input/output jacks. See
"Connection" on page 14
Muting the sound
1.
Open the OSD menu and go to the BASIC > Audio Settings > Mute menu.
2.
Press
/
If available, you can press
and off.
Adjusting the sound level
1.
Open the OSD menu and go to the BASIC > Audio Settings > Audio Volume menu.
2.
Press
/
If available, you can press
level.
Turning off the Power On/Off Ring Tone
1.
Open the OSD menu and go to the BASIC > Audio Settings > Power On/Off Ring
Tone menu.
2.
Press
/
The only way to change Power On/Off Ring Tone is setting On or Off here. Setting the sound
mute or changing the sound level will not affect the Power On/Off Ring Tone.
for more details.
to select On.
on the remote control to toggle the projector audio between on
to select a desired sound level.
or
on the remote control to adjust the projector's sound
to select Off.
33
Connection
chapter.
Advertisement
Table of Contents
