Table of Contents
Advertisement
Utilizing the password function
For security purposes and to help prevent unauthorized use, the projector includes an option
for setting up password security. The password can be set through the On-Screen Display
(OSD) menu. For details of the OSD menu operation, please refer to
page
19.
You will be inconvenienced if you enable the password function yet forget the password
somehow. Do make a note of your password, and keep the note in a safe place for later recall.
Setting a password
Once a password has been set and the power on lock is enabled, the projector cannot be used
unless the correct password is entered every time the projector is started.
1.
Open the OSD menu and go to the SYSTEM > Security Settings > Change
Password menu.
2.
Press Enter and the password dialog box is displayed.
3.
Highlight Power On Lock and select On by pressing
4.
As pictured to the right, the four arrow keys
(
,
,
4). According to the password you desire to set, press
the arrow keys to enter six digits for the password.
5.
Confirm the new password by re-entering the new
password.
Once the password is set, the OSD menu returns to the
Security Settings page.
6.
To leave the OSD menu, press Exit.
If you forget the password
If the password function is activated, you will be
asked to enter the six-digit password every time you
turn on the projector. If you enter the wrong
password, the password error message as pictured
to the right is displayed lasting for 5 seconds, and
the message 'INPUT PASSWORD' follows. You
can retry by entering another six-digit password, or if you did not record the password in
this user manual, and you absolutely do not remember it, you can use the password recall
procedure. See
"Entering the password recall procedure" on page 21
If you enter an incorrect password 5 times in succession, the projector will automatically
shut down in a short time.
,
) respectively represent 4 digits (1, 2, 3,
20
"Using the menus" on
/
.
for details.
Advertisement
Table of Contents
