Table of Contents
Advertisement
Fine-tuning the image clarity
1.
Adjust the projected image to the size
that you need using the zoom ring.
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to
angled projection.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
•
Using the remote control
1.
Press
/
correction page.
2.
Press
to correct keystoning at the top of
the image. Press
the bottom of the image.
•
Using the OSD menu
1.
Open the OSD menu and go to the
2.
Press Enter. The Keystone correction page is displayed.
3.
Press
to correct keystoning at the top of the image or press
keystoning at the bottom of the image.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
•
Using the OSD menu
1.
Open the OSD menu and go to the
2.
Press Enter. The Zoom bar is displayed.
3.
To navigate the picture, press Enter to switch to the paning mode and press the
directional arrows (
4.
To reduce size of the picture, press Enter to switch back to the zoom in/out
functionality, and press
also press Auto Sync on the remote control to restore the picture to its original size.
The picture can only be navigated after it is magnified. You can further magnify the picture
while searching for details.
Selecting the aspect ratio
The 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and
computers are in 4:3 ratio, and digital TV and DVDs are usually in 16:9 ratio.
2.
to display the Keystone
to correct keystoning at
DISPLAY >
DISPLAY >
,
,
,
) to navigate the picture.
repeatedly until it is restored to the original size. You can
24
If necessary, sharpen the image by rotating
the focus ring.
/
Press
Keystone menu.
Zoom menu.
/
Press
to correct
Advertisement
Table of Contents
