D-Link SECURICAM DCS-2100 User Manual page 41

DCS-2100 User's Manual
Follow these steps to configure your router's Virtual Server settings:
1 Click Enabled.
2 Enter a different name for each entry.
3 Enter your camera's local IP Address (e.g., 192.168.0.102 in the example in
step 2 on page 38) in the Private IP field.
4 Select Both under Protocol Type (TCP and UDP)
5 If you are using the default camera port settings, enter 80 into the Public and
Private Port section, click Apply.
6 Scheduling should be set to Always so that the camera images can be accessed
at any time.
Repeat the above steps adding ports 5001, 5002, and 5003 to both the Public and
Private Port sections. A check mark appearing before the entry name will indicate that
the ports are enabled.
Important: Some ISPs block access to port 80 and other commonly used Internet ports
to conserve bandwidth. Check with your ISP so that you can open the appropriate ports
accordingly. If your ISP does not pass traffic on port 80, you will need to change the port
the camera uses from 80 to something else, such as 800. Not all routers are the same,
so refer to your user manual for specific instructions on how to open ports.
Enter valid ports in the Virtual Server section of your router. Please make sure to check
the box next to the camera name on the Virtual Server List to enable your settings.
D-Link Systems, Inc.
Using & Configuring the DCS-2100 with a NAT Router
41