Advertisement
D-Link Co.,_______________________________________________________________________ FAQ
4.
Will my screen blank out if I stay in menu 24.1?
No.
If you keep your system on menu 24.1, the system will not
timeout after the five minutes has elapsed.
5.
What can I do if I don't know the IP address of the device I am
connecting to?
In some cases, your Internet Service Provider (ISP) or other
remote node you wish to connect to will not know their IP
address.
You can work around this problem by using the Internet Setup Menu
(menu 4) to configure your remote node.
the option to leave the ISP's IP address field blank or simply
enter 0.0.0.0.
address sent from that device.
If you want the remote device to dynamically assign an IP to the
Router, then you need to turn on the Single User Account feature,
and leave the IP Addr field blank or filled with 0.0.0.0.
6.
Why do I see garbage characters being printed out on my console?
This condition is due to data overflowing the UART.
have a 16650 UART chip on your serial port, or you might not have
flow control working correctly on that port.
caused by this data overflow.
escaping back one menu and then re-entering the screen.
7.
My Router inexplicably reboots itself.
The could be a problem with the power supply connection on the
rear panel of the Router.
causing the Router to reboot itself.
cable, make sure that you apply the force behind the sliding
collar and not holding it.
To test if the connection is firm, hold the back of the power
cable plug, just behind the sliding collar, and try pulling the
cable out.
pull the cable out without pulling the sliding collar back.
8.
Why can't I get the callback feature to work when I dial from a
workstation to the Router?
Router only supports Microsoft's proprietary CallBack Control
Protocol (CBCP).
callback to other devices that also support CBCP, such as Win95
or NT.
If you are using Trumpet or other application that
doesn't support CBCP, Router will not callback.
9.
Dial-in users to the Router cannot talk to some or all of the
stations on the LAN side of Router, or access Internet through
another router on the LAN (Dial-in user are using IP address in
IP pool) Why?
In these cases, the Router will accept any IP
The connection may be loose and
This will ensure a good connection.
If the connection is firm, you should not be able to
Thus, the Router will only be able to do PPP
In this screen, you have
There is no harm
You can repaint the screen by
Why?
When you plug in the power
You may not
FAQ: 20
Advertisement
