Method Setup - Fc - Vial Numbers - Teledyne Foxy R1 Manual

Teledyne Foxy R1 - R2

4.2 Method Setup - FC - Vial Numbers

The Method Setup - FC - Vial Numbers
of the Teledyne Foxy R1 - R2 fraction collector.
Start Vial Number
Vial Number
Sets the number of the vial where the first collected fraction will be stored.
The current vial number is incremented each time the Next signal is
activated. The vial number is stored in the Results Table.
Reset at
Specifies the conditions of the current vial number setting to Start Vial
Number in three different situations:
Each Run - the vial number is reset at the start of each acquisition.
Start Sequence - the vial number is reset only at the start of a
sequence.
Open Instrument - the vial number is reset only once, when the
Instrument is opened.
Last Vial Number
Vial Number
Sets the number of the last available vial.
After Last Vial
Specifies the action executed when current vial number exceeds the Last
Vial Number.
Fig 7: Method Setup - FC - Vial Numbers
4 Using the control module
tab is used for setting the behavior
- 12 -