Advertisement
Quick Links
Download this manual
See also:
Operating Manual
CH-DVR 1500 Manual Addendum
EJECT BUTTON IS UNRESPONSIVE - DISC TRAY DOESN'T OPEN
When the CH-DVR 1500 DVD Recorder is first turned on it will enter INITIAL
SETUP MODE which allows the Time/Date and Language to be set. While the
DVD Recorder is in this mode, the word CYBERHOME will be shown on the front
panel and some of the buttons on the front of the recorder, such as EJECT, will not
function until the Initial Setup is completed.
If you wish to SKIP the Initial Setup and open the disc tray, press ENTER -
RETURN - ENTER on the front panel. Make sure to press each button only once.
This will return the unit to normal operation and allow the disc tray to be opened.
COMPLETING THE INITIAL SETUP PROCEDURE
To complete the Initial Setup procedure, you must connect the Composite Video output to your TV and use the
remote control or front panel navigation buttons to choose the Setup Language and set the Time/Date.
1
Connect the Composite Video Out (Yellow Connector)
from the back panel of the CH-DVR 1500 to your TV's
corresponding Video Input. *If your TV does not have
at least a Composite Video Input, you cannot connect
the unit directly. In this case you would need an RF
MODULATOR to use this or any DVD Player with
your Television.
RF Connector
is used for
TV Input Signal
Only
2
Select the Video Input on your TV that corresponds to the Composite or S-Video input, whichever is in
use. With most TVs, this is done by pressing the INPUT or VIDEO IN button on the remote. Some TVs
may require you to choose a particular channel.
3
Once the Initial Setup Screen appears on your TV, you can use the remote control or front panel
navigation buttons to choose a language and set the time and date.
Choose English Menus
Choose Spanish Menus
Press <ENTER> to continue
4
When the Initial Setup is complete the EJECT and other buttons will function normally.
Note: The threaded, coaxial RF connector on the back of the CH-DVR 1500 DOES NOT
CARRY the video output signal from the DVD Recorder. This connector is only used for
an antenna or cable TV input. YOU CANNOT USE the splitter to output the signal from
the DVD Recorder to your TV. The splitter is used ONLY to send the antenna or cable
TV signal to the DVD Recorder and/or your TV.
Please set the Time and Date
00:05:10
01/01/00
Completed
!
Composite Video
Output Jack
Advertisement
