Solid-State Drive (Ssd) - HP 14-BS0 Series Maintenance And Service Manual

Solid-state drive (SSD)

Description
512 GB solid-state drive
256 GB solid-state drive
128 GB solid-state drive
Mylar for use with solid-state drives
Before removing the solid-state drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to reassemble and install the solid-state drive.
Battery on page
Optical drive on page
Bottom cover on page
Solid-state drives are designed with notches to prevent incorrect insertion.
32).
34), if installed.
41).
Component replacement procedures
Spare part number
763008-015
865902-011
827560-040
930980-001
51