Setting And Checking - SMC Networks HRSH Series Operation Manual

22.
Select contact output signal 1 operation from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set values
Contact output 1 selected alarm
23.
Press the [SEL] key once.
The set screen of digital output 1 selected alarm is displayed on the digital display.
PV
SV
24.
Select contact output 1 selected alarm from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set values
to
Contact output 2 function Setting and checking
25.
Press the [SEL] key once.
The set screen of contact output 2 function is displayed on the digital display.
PV
SV
HRSH Series
Table 2.4-12 List of set values
Explanation
N.O type
N.C type

Setting and checking

Table 2.4-13 List of set values
Explanation
Setting/checking are not available unless the
function setting of contact output 1 is selected
alarm status signal.
Sets selection alarm.
Set range is AL.01 to AL.49.
Chapter 2 Contact input/output communication
Initial value
(Default setting)
Initial value
(Default setting)
HRX-OM-Q033
○
2.4 Setting and checking
2-11