Curtis DVD2100 User Manual page 13

System Setup
To satisfy customers with different characteristics and suit related devices of different qualities, the unit provides
various functions. You can setup the system of the unit and regulate its operations to meet your taste and suit well
with other related devices of yours. But if you think it's too complex, you may also use the default settings, which
can meet your basic demand.
Operation Interface and General Steps
This section will introduce the menu interface of the System Setup and general operation steps.
1.Press the SETUP button to enter the System Setup mode. Now the system setup control bar menu will appear
on the top of the OSD, as shown in the following chart.
The meanings of the icons are as follows.
1)GRNERAL Settings
2)PLAYBACK Settings
3)RECORD Settings
4)LANGUAGE Settings
5)CHANNEL SCAN
6)CLOCK Settings
2.Use the or button to select items to be setup in the control bar and press the
setup menu of the item. In the setup menu of a certain item, press the arrow buttons and the
to operate some control units, and the corresponding setting will be done.
3.Press the RETURN button to return to the upper level menu. Press the SETUP
etup mode.
Note
The above steps are general and typical operations. Some settings might not need a certain step, or require more
steps.
Please set up the system in the Eject Disc mode or No Disc mode, or some settings cannot be done.
General Settings
1.Enter the System Setup mode.
2.In the System Setup control bar menu, use the
3.Press the SELECT button to enter the General Settings menu, as shown in the chart.
System Setup (General)
1
System Setup (General)
Screen Saver
On
Progressive/Interlace
Interlace
Video Output Format
PAL
Restore Factory Settings
OK
1
SELECT button to enter the
SELECT
button to exit the System
or button to select the General item.
Screen Saver On
Progressive/Interlace Interlace
Video Output Format PAL
Restore Factory Settings OK
35
System Connection
button
Connected to an amplifier with digital decoder
In Audio Setup, set the
Audio Output
When using a digital signal output (coaxial or optical), the Analog Output cable is not needed for connection.
Amplifier 1
5.1 Channel
Ordinary Cable
(Analog Output)
Audio Source Cable or
Amplifie
Digital Output Mode to LPCM Output
for reference).
12
The Rear Panel of the Unit
The Rear Panel of the Unit
(For details, see System Setup-Digital