Remote Operation - Panasonic KX-PRS120C Operating Instructions Manual

Answering System
4
Enter the desired name (16 characters
max.). a MOKN
5
Enter the desired number (24 digits
max.). a MOKN a MSelectN a MOFFN
Turning on/off the new message alert
setting
1
MMenuN (right soft key) #338
2
MbN: "On/Off" a MSelectN
3
MbN: Select the desired setting. a
MSaveN a MOFFN
Editing the set phone number
1
MMenuN (right soft key) #338
2
MbN: "Notification to" a MSelectN
3
MMenuN a MbN: "Edit" a MSelectN
4
Edit the name if necessary (16 characters
max.). a MOKN
5
Edit the phone number if necessary (24
digits max.). a MOKN a MSelectN a
MOFFN
Erasing the set phone number
1
MMenuN (right soft key) #338
2
MbN: "Notification to" a MSelectN
3
MMenuN a MbN: "Erase" a MSelectN
4
MbN: "Yes" a MSelectN a MOFFN
R The new message alert setting is
turned off.
Activating/inactivating the remote
access code to play messages
If you activate this feature, you must enter the
remote access code (page 38) to play the
new message from the new message alert
call. This is so that unauthorized parties
cannot listen to your messages. The default
setting is "Inactivate".
– "Inactivate": You can listen to the
message by pressing 4 to play new
messages (without entering the remote
access code).
38
PRS120C(en)_0121_ver110.pdf
– "Activate": You must enter your remote
1
2
3
Listening to messages
After you answer the new message alert, you
can listen to the messages as follows.
n When the remote access code is set to
n When the remote access code is set to
Note:
R Within 10 seconds after listening to new
R Even if the unit makes a new message alert

Remote operation

Using a touch-tone phone, you can call your
phone number from outside and access the
unit to listen to messages or change
answering system settings. The unit's voice
guidance prompts you to press certain dial
keys to perform different operations.
Remote access code
A 3-digit remote access code must be entered
when operating the answering system
remotely. This code prevents unauthorized
parties from listening to your messages
remotely. The default setting is "111".
38
access code (page 38) and then press 4
to play new message.
MMenuN (right soft key) #338
MbN: "Remote code" a MSelectN
MbN: "Activate" or "Inactivate" a
MSaveN a MOFFN
"Inactivate":
Press 4 to play the new message during
the announcement.
"Activate":
1
Enter the remote access code
(page 38) during the announcement.
2
Press 4 to play the new message.
messages, you can press #9 during the
call to turn off the new message alert by a
call feature.
call, the handset redial list does not show
the record.
2014/01/29 14:56:59