Stihl FS 90 Instruction Manual page 17

8
Place the secured assembly on the
N
handle support (8) with the wing
screw at the side nearest the
engine.
Push the wing screw into the handle
N
support as far as stop and then
screw it down – but do not finally
tighten yet.
Line up the handlebar at a right
N
angle to the drive tube – check
distance A again.
Tighten down the wing screw firmly.
N
FS 90, FS 90 R
Mounting the control handle
Take out the screw (9) – the nut (10)
N
remains in the control handle (11).
Push the control handle onto the
N
handlebar (7) until the holes (13)
line up – the throttle trigger (12)
must point towards the gearbox.
Insert the screw (9) and tighten it
N
down firmly.
Fitting the throttle cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
14
15
15
14
15
Push the throttle cable (14) into the
N
retainers (15).
Adjusting the throttle cable
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
English
15