Mounting The Deflector - Stihl FS 70 Instruction Manual

4
7
8
9
1
1
Place the clamp (7) in the loop
N
handle (4) and position them both
against the drive tube (8).
Position the clamp (8) against the
N
drive tube.
Place the barrier bar (6) in position
N
as shown.
Line up the holes.
N
Insert the screws (1) in the holes
N
and screw them into the barrier bar
as far as stop.
Go to "Adjusting and Securing the
N
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
FS 70 R
Adjusting and Securing the Loop Handle
6
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 15 cm (5.9 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
A
4

Mounting the Deflector

Use the right deflector
WARNING
Deflector (1) is approved for mowing
heads only and must therefore be
mounted before fitting a mowing head
2
WARNING
Deflector (2) is approved for grass
cutting blades only and must therefore
be mounted before fitting a grass cutting
blade.
Mounting the Deflector
Deflectors (1) and (2) are both mounted
to the gearbox in the same way.
English
1
13