Table of Contents
Advertisement
AXIS Q8665-LE PTZ Network Camera
About PTZ (Pan Tilt Zoom)
The Panel Shortcut Command Buttons list shows the user-defined buttons that can be accessed from the Live View page's Ctrl
panel. These buttons can be used to provide direct access to commands issued using the VAPIX® application programming interface.
Click Add to add a new shortcut command button.
The following PTZ controls are enabled by default:
•
Pan control
•
Tilt control
•
Zoom control
•
Focus control
To disable specific controls, deselect the options under Enable/Disable controls.
Note
Disabling PTZ controls will not affect preset positions. For example, if the tilt control is disabled, the product can still move to
preset positions that require a tilt movement.
Configure the Wiper
The product is equipped with a wiper to enable wiping of the protective window.
The wiper can be configured to operate for a set amount of time. To configure the wiper sequence:
1. Go to PTZ>Advanced>Device.
2. In Wiper dwell time, enter a value between 1–60 (seconds) to set the duration of the sequence. This value applies only to
the wiper sequence and has no effect on the washer configuration described below.
3. Click Save.
Configure the Washer
The product can be equipped with an optional washer (not included) to enable cleaning of the protective window.
To enable the washer button on the Live view page and configure the washer:
1. Go to Live View.
2. Click Set emulated joystick mode, see PTZ Controls on page 14.
3. Use the joystick to position the washer nozzle in the center of the live view image.
4. Go to PTZ>Advanced>Device.
5. Select Nozzle Position.
6. In Washer Configuration, enter a value (1 or 2) to select the desired washer configuration. Typically select Washer
Configuration 1 if the washer liquid tank is located close to the nozzle. Select Washer Configuration 2 if the washer liquid
tank is located further away from the nozzle. See the table below for more details about the washer configurations.
7. Click Save.
Time (seconds)
0
5
10
Washer Configuration 1
Washer fluid pump starts
Wiper starts
Washer fluid pump stops
31
Washer Configuration 2
Washer fluid pump starts
—
—
Advertisement
Table of Contents
