Axis Q8665-LE User Manual page 13

AXIS Q8665-LE PTZ Network Camera
How to access the product
About the manual trigger
The Manual Trigger is used to trigger an action rule from the Live View page. The manual trigger can for example be used to
validate actions during product installation and configuration.
To configure the manual trigger:
1. Go to Setup > Events.
2. Click Add to add a new action rule.
3. From the Trigger drop-down list, select Input Signal.
4. From the second drop-down list, select Manual Trigger.
5. Select the desired action and configure the other settings as required.
For more information about action rules, see About events on page 37.
To show the manual trigger buttons in the Live View page:
1. Go to Setup > Live View Config.
2. Under Action Buttons, select Show manual trigger button.
About the AXIS Media Control viewer toolbar
The AXIS Media Control viewer toolbar is available in Internet Explorer only. See About AXIS Media Control (AMC) on page 15 for
more information. The toolbar displays the following buttons:
The product is equipped with a wiper to enable wiping of the protective window. Click Start wiper
to start the wiper. Click Stop wiper
the wiper for a set amount of time. For information about how to configure the wiper, see Configure
the Wiper on page 31.
The product can be equipped with a washer to enable cleaning of the protective window. Click Start
wash to start the washing sequence. For information about the washing sequence and how to enable
and configure the washer, see Configure the Washer on page 31.
Use the Manual Trigger button to trigger an action rule from the live view window. For information
about how to configure and enable the button, see About the manual trigger on page 13.
Click Snapshot to save a snapshot of the video image. This button is primarily intended for use when
the AXIS Media Control viewer toolbar is not available. Enable this button from Live View Config >
Action Buttons.
The product's heater is controlled by the ambient temperature and is turned on and off automatically.
If required, the heater can be activated manually by clicking the Heater button. To show the button,
go to Setup > Live View Config. Under Action Buttons, select Show heater button and specify the
number of minutes the heater should be activated.
Enable or disable the Gatekeeper by selecting On or Off from the drop-down list. For more information
about the Gatekeeper, see page 29.
Activate or de-activate IR illumination from Setup > Video > Camera Settings. Enable this button from
Live View Config > Action Buttons.
to stop the wiper. Click Start wiper sequence
13
to activate