Table of Contents
Advertisement
SUPERSTORESYSTEM 6048R-DE2CR24L User's Manual
BMC Enable
Close pins 1/2 of jumper JPB1 to
enable the ASpeed AST 2400 BMC
(Baseboard Management Controller)
to provide IPMI 2.0/KVM support on
the motherboard. Please install an
SMCI-proprietary cable (CBL-218L)
on the connector JKVM1 on the I/O
backplane for KVM support. See the
table on the right for jumper settings.
5-9
Onboard Indicators
LAN LEDs
The Ethernet ports (located on the
I/O backplane) have two LEDs. On
each port: the orange LED fl ashes to
indicate activity while the other LED
may be green, amber or off to indicate
the speed of the connection. Please
note that LAN1 also functions as an
IPMI LAN. See the table on the right
for the functions associated with the
connection speed LED.
BMC Heartbeat LED
A BMC Heartbeat LED is located at
LEDH, the upper LED on I/O back
panel. When LEDH is blinking, the
BMC is functioning normally. See the
table at right for more information.
(PCH) HDD LED
The (PCH) HDD LED is located at
HDD LED1 on the motherboard. When
this LED is blinking, HDD supported by
the Intel PCH is active. See the table
at right for more information.
BMC Enable
Jumper Settings
Jumper Setting
Pins 1-2
Pins 2-3
Link LED
10Gbps LAN1/2 Link LED
(Connection Speed Indicator)
LED Color
Defi nition
Off
No Connection, 10 Mb/s or 10 Mb/s
Amber
1 Gb/s
Green
10 Gb/s
BMC Heartbeat/System
Heartbeat LED Status
State
Green Blinking
(PCH) HDD Activity LED
State
Green: Blinking
5-16
Defi nition
BMC Enable (Default)
Disabled
LAN
Activity LED
Defi nition
BMC Normal
LED Status
Defi nition
PCH HDD: Active
Advertisement
Table of Contents
