Table of Contents
Advertisement
SUPERSTORESYSTEM 6048R-DE2CR24L User's Manual
Installing a CPU Heatsink
1. Remove power from the system and unplug the AC power cord from the
power supply.
2. Place the heatsink on top of the CPU so that the four mounting holes are
aligned with those on the (preinstalled) heatsink retention mechanism.
3. Screw in two diagonal screws (i.e. the #1 and the #2 screws) until just snug.
Do not fully tighten the screws or you may damage the CPU.)
4. Add the two remaining screws then fi nish the installation by fully tightening all
four screws.
Screw #3
Removing the Heatsink
•
Warning: Removing the CPU or the heatsink is not recommended. If you do
need to remove the heatsink, please follow the instructions below to prevent
damage to the CPU or other components.
1. Power down the node and unplug the AC power cord.
2. Unscrew and remove the heatsink screws in the sequence shown in the
illustration above.
3. Hold the heatsink and gently wiggle it to loosen it from the CPU. (Do not use
excessive force when doing this!) Once the heatsink is loosened, remove it
from the CPU.
4. Clean the surface of the CPU and the heatsink to get rid of the old thermal
grease. Reapply the proper amount of thermal grease before you re-install
the heatsink.
Screw #2
5-6
Screw #1 (behind)
Screw #4
Advertisement
Table of Contents
