Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
After first 10 hours
After first 50 hours
Every 50 hours
Every 150 hours
Every 200 hours
Every 400 hours
Every 800 hours or
annually, whichever
occurs first
Every 1000 hours or 2
years, whichever occurs
first
Important
Refer to your engine operator's manual and cutting unit operator's manual for additional maintenance
procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.
Maintenance Procedure
• Check the fan and alternator belt tension.
• Replace the hydraulic filter.
• Torque the wheel lug nuts.
• Change the engine oil and filter.
• Check the engine RPM (at idle and full throttle).
• Inspect the air filter, dust cup, and burp valve.
• Lubricate all grease fittings.
• Check the battery cable connections.
• Check the fan and alternator belt tension.
• Check the battery fluid level.
• Change the engine oil and filter.
• Inspect the traction belt.
• Replace the air filter.
• Replace the hydraulic filter.
• Torque the wheel lug nuts.
• Replace the hydraulic fluid.
• Replace the fuel/water separator filter.
• Replace the fuel prefilter.
• Inspect the traction cable movement.
• Check the engine RPM (at idle and full throttle).
• Adjust the valves.
• Inspect, disassemble and install new seals in cutting unit roller assemblies.
• Replace all moving hoses.
• Replace the safety switches.
• Flush the cooling system and replace the fluid.
• Drain and flush the fuel tank.
• Drain and flush the hydraulic tank.
Caution
28
Advertisement
Table of Contents
