Table of Contents
Advertisement
7
8
10
11
Figure 18
1. Throttle
2. Hour meter
3. Temperature light
4. Oil pressure light
5. Glow plug indicator light
6. Alternator light
Cutting Unit Shift Lever
To lower the cutting units to the ground, move the cutting
unit shift lever (Fig. 18) forward. The cutting units will not
drop unless the engine is running. To raise the cutting units,
pull the shift lever rearward to the Raise position.
Note: The lever does not have to be held in the forward
position while the cutting units are lowered.
Engine Coolant Temperature Warning
Light
The temperature warning light (Fig. 18) glows if the engine
coolant temperature is high. If the traction unit is not
stopped and the coolant temperature rises another 10°F, the
engine will kill.
Oil Pressure Warning Light
The oil pressure warning light (Fig. 18) glows if the engine
oil pressure drops below a safe level.
Alternator Light
The alternator light (Fig. 18) should be off when the engine
is running. If it is on, the charging system should be
checked and repaired as necessary.
Glow Plug Indicator
The glow plug indicator light (Fig. 18) will glow when the
glow plugs are operating.
4
3
2
6
5
9
1
7. Cutting unit drive switch
8. Cutting unit shift lever
9. Ignition switch
10. Parking brake
11. Lift lever lock
20
Parking Brake
Whenever the engine is shut off, the parking brake (Fig. 18)
must be engaged to prevent accidental movement of the
machine. To engage the parking brake, pull up on the lever.
The engine will stop if the traction pedal is depressed with
the parking brake engaged.
Lift Lever Lock
Move the lift lever lock (Fig. 18) rearward to prevent the
cutting units from dropping.
Fuel Gauge
The fuel gauge (Fig. 19) registers the amount of fuel in the
tank.
Seat Adjustments
Fore and Aft Adjustment (Fig. 19)—Move the lever on the
side of the seat outward, slide the seat to the desired
position, and release the lever to lock the seat into position.
2
Figure 19
1. Fore and aft lever
Starting and Stopping the
Engine
Important
The fuel system may have to be bled if any
of the following situations have occurred:
• Initial start up of a new engine
• The engine has ceased running due to lack of fuel.
• Maintenance has been performed upon the fuel system
components; i.e. filter replaced, etc.
Refer to Bleeding the Fuel System, page 21.
1
2. Fuel gauge
Advertisement
Table of Contents
