Table of Contents
Advertisement
Servicing the Engine Oil and
Filter
Change the oil and filter initially after the first 50 hours of
operation; thereafter change the oil and filter every 150
hours.
1. Remove either drain plug (Fig. 38) and let oil flow into
a drain pan. When the oil stops flowing, install the drain
plug.
1
Figure 38
1. Engine oil drain plug
2. Remove the oil filter (Fig. 39). Apply a light coat of
clean oil to the new filter seal before screwing it on. Do
not overtighten.
3. Add oil to the crankcase; refer to Checking the
Crankcase Oil, page 16.
Figure 39
1. Engine oil filter
Servicing the Fuel System
Fuel Tank
Drain and clean the fuel tank every 2 years. Also, drain and
clean the tank if the fuel system becomes contaminated or
if the machine will be stored for an extended period of
time. Use clean fuel to flush out the tank.
Fuel Lines and Connections
Check the fuel lines and connections every 400 hours or
yearly, whichever comes first. Inspect them for
deterioration, damage, or loose connections.
Water Separator
Drain water or other contaminants from the water separator
(Fig. 40) daily.
1. Place a clean container under the fuel filter.
2. Loosen the drain plug on the bottom of the filter
1. Water separator
Replace the filter canister after every 400 hours of
operation.
1
1. Clean the area where the filter canister mounts.
2. Remove the filter canister and clean the mounting
3. Lubricate the gasket on the filter canister with clean oil.
4. Install the filter canister by hand until the gasket
35
canister (Fig. 40). Tighten the plug after draining.
1
2
Figure 40
surface.
contacts the mounting surface; then rotate an additional
1/2 turn.
2. Drain plug
Advertisement
Table of Contents
