Table of Contents
Advertisement
A
CAUTION:
cause noise problem.
CAUTION:
must be removed and the water inside the product must be drained when the product is not
in use.
CAUTION:
In order to clean the dirty filter and discharge the water:
1 Unplug the product to cut off the supply power.
A
CAUTION:
the burning risk, clean the filter after the water inside the product is cooled down.
2. Open the filter cover.
3 Follow the below procedures in order to drain water.
Product has an emergency water draining hose, in order to drain the water:
4 Clean any residues inside the filter as well as fibers, if any, around the pump impeller
region.
5. Replace the filter.
6. If the filter cap is composed of two pieces, close the filter cap by pressing on the tab. If
it is one piece, seat the tabs in the lower part into their places first, and then press the
upper part to close.
Washing Machine / User's Manual
Foreign substances left in the pump filter may damage your product or may
In regions where freezing is possible, the faucet must be closed, system hose
After each use, turn off the water tap to which the mains hose is connected.
Temperature of the water inside the product may rise up to 90 ºC. To avoid
Filter cap is composed of two pieces,
press the tab on the filter cap
downwards and pull the piece out
towards yourself.
a
Pull the emergency draining hose out
from its seat
b
Place a large container at the end of the
hose. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is full, block
the inlet of the hose by replacing the
plug. After the container is emptied,
repeat the above procedure to drain the
water in the product completely.
c
When draining of water is finished,
close the end by the plug again and fix
the hose in its place.
d
Turn and remove the pump filter.
39 / EN
Advertisement
Table of Contents
