Table of Contents
Advertisement
4.4 Installation
• Preparation of the location and electrical, tap water and waste water installations at the
place of installation is under customer's responsibility.
• Make sure that the water inlet and discharge hoses as well as the power cable are not
folded, pinched or crushed while pushing the product into its place after installation or
cleaning procedures.
• Make sure that the installation and electrical connections of the product are performed
by competent persons. Manufacturer shall not be held liable for damages that may arise
from procedures carried out by unauthorized persons.
• Prior to installation, visually check if the product has any defects on it. If so, do not have
it installed. Damaged products cause risks for your safety.
4.4.1 Appropriate installation location
• Place the product on a hard and level floor. Do not put it onto a carpet with high pile or
other similar surfaces.
• When the washing machine and drier are placed on top of each other, their total weight
–when loaded– amounts to 180 kilograms. Place the product on a solid and flat floor that
has sufficient load carrying capacity!
• Do not place the product on the power cable.
• Do not install the product in the environments where the temperature falls below 0 ºC.
• Leave a minimum space of 1 cm between the machine and the furniture.
• On a graduated floor, do not place the product next to the edge or on a platform.
12 / EN
Washing Machine / User's Manual
Advertisement
Table of Contents
