Table of Contents
Advertisement
Preparing the Camera
Only when using a compatible CINE-SERVO
lens (A 71)
6 Connect the lens's 12-pin cable to the camera's
LENS terminal.
7 Set the Q switch to ON.
8 On the lens's MENU screen, select the signal path
for data communication with the camera.
24
• In the [Info] screen, set [I/Fprior] to [Mount].
Removing an EF Lens
1 Set the Q switch to OFF.
• If a CINE-SERVO lens is connected to the
camera's LENS terminal, disconnect the 12-pin
cable after turning off the camera.
2 While holding the bottom of the lens, turn the lens
mount handle clockwise until it stops and remove
the lens.
• Make sure not to drop the lens when removing it.
3 Place the body cap back on the lens mount and
the dust caps back on the lens.
NOTES
• About using an EF-S lens: This camera's sensor is larger than the sensor size for which EF-S lenses
are designed (APS-C). When using EF-S lenses with this camera, you may notice peripheral
illumination fall-off or vignetting. To prevent this, you can use the [Camera Setup] > [EF-S Lens]
setting to change the sensor area that is used for producing the image. This setting digitally
enlarges the image by a factor of approx. 1.04 so the image quality will deteriorate slightly.
• Depending on the lens's characteristics, the corners of the picture may seem darker due to light fall-
off or illumination drop. You can use the [Camera Setup] > [Periph.Illum.Corr.] setting to have the
camera compensate if it has the correction data available for the lens.
• If you are using a compatible lens*, you can use the [Camera Setup] > [Zoom-Iris Correct.] setting
to have the camera adjust the aperture while zooming.
* Some EF lenses and CINE-SERVO lenses are not compatible with this function.
Advertisement
Table of Contents
