Table of Contents
Advertisement
Preparing the Camera
Preparing the Camera
This section outlines the basic preparations for the camera.
Adjusting the Black Balance
The first time you use the camera or if there is a noticeable change in the blacks of the video signal
22
(such as when ambient temperature changes considerably), you can have the camera adjust the black
balance automatically.
1 Set the Q switch to OFF and prepare the camera.
• When using a compatible CINE-SERVO lens (A 71):
Attach the CINE-SERVO lens (A 23).
When using other lenses: Remove the lens if one is
attached to the camera, and attach the body cap to the
lens mount.
2 Set the Q switch to ON.
3 Press the ABB button.
• Alternatively, you can use the [Camera Setup] > [ABB]
setting.
4 Select [OK] and then press SET.
• The automatic black balance procedure will start. It will take approximately 40 seconds when the
frame rate is set to 23.98P.
5 When the message [Process completed successfully.] appears, press SET.
• If the sensor is not completely shielded from light, [ABB error] will appear on the screen. Press
SET and repeat the procedure from the beginning.
NOTES
• Adjusting the black balance is necessary in the following cases:
- After a long period of not using the camera.
- After sudden or extreme changes in ambient temperature.
- After resetting the camera's settings using either option in the [Other Functions] > [Reset]
setting.
• During the adjustment of the black balance, you may notice some irregular displays appear on the
screen. This is not a malfunction.
• After adjusting the black balance with a CINE-SERVO lens attached to the camera, you will need to
readjust the aperture.
Advertisement
Table of Contents
