Table of Contents
Advertisement
Preparing the Power Supply
Using the DC IN 2 Terminal
Follow this procedure to prepare a power cable using the supplied power connector and power the
camera using the DC IN 2 terminal.
DC IN 2 terminal configuration
Polarity
16
+
-
1 Strip the insulation from the tips of the power
cable wires.
• For reference only: The wire gauge of power cables
that can be used is AWG 24 to 16.
2 Insert the tips of the wires into the supplied power
connector as shown in the illustration.
• Make sure to connect the wires to match the polarity
indicators on the DC IN 2 terminal.
3 Tighten the screws of the supplied power
connector to securely attach the wires.
• Set a tightening torque of no more than 0.25 N·m.
4 Set the Q switch to OFF.
5 Insert the power connector into the DC IN 2
terminal.
IMPORTANT
• Make sure to use an external power supply that meets
the standards of the country/region where it is used.
Furthermore, make sure the external power supply is a
double-insulated device and is insulated for commercial
power use.
Signal
11 to 17 V DC
Ground
Terminal type: 2-pin socket
(male connector)
Polarity: -
Approx. 5 to 7 mm
(0.20 to 0.28 in.)
Torque: 0.25 N·m
(max.)
Polarity: +
Power connector
(supplied)
Strip
Advertisement
Table of Contents
