Paging (Intercom); Redial - Cisco SPA 303 Manual

Call Park Groups.
To Park a Call:
1. While on a call, press the park soft
2. The phone will respond with a voice prompt such as "Call Parked
o n 9001". The caller will hear hold music.
3. To pick up the parked call, anyone on any phone may dial the park
number (9001 in this example) to be connected with the caller.
When a call is parked on a phone, one of the lines on that phone
is used until the call is picked up by another phone.
Note

Paging (Intercom)

To page to all phones
Paging allows you to speak to all phones at the same time through their
speaker phone. If you pick up the handset during a page, you will hear
the message in the handset. Paging is used to make announcements
such as "Jim, you have a visitor in the lobby" or to let people know about
a parked call such as "Susan, you have a call waiting on Park 9001".
Paging will only notify phones not in use or not set to DND.
To group specific phones so only they receive specific Paging calls, login to
the Admin Portal and click the Groups Tab then select Paging Groups.
Initiating a Page
1. Either pick-up the handset or uses the speaker phone.
2. Dial the Paging Group (9100 is the Standard Paging Group for all
phones).
3. Wait for the tone.
4. Make your announcement which will be heard on all phones.
(Except phones set to DND or phones in use)
5. Hang up the phone when finished.

Redial

The Redial function places a call to the last number dialed. To use the
Redial function, use the redial soft key.
If a number on an incoming call matches a number in the system
speed dial list, the name in the list will be displayed.
Note
key.
23