Note: If The Transfer Party Does Not Pick Up The Phone, Touch #6 To Return To The Original Caller; Paging (Intercom) - Cisco SPA525G2 Owner's Manual

Note: If the transfer party does not pick up the phone, touch #6 to
return to the original caller.
Call Park
To Park a call
Parking a call is very similar to putting a call on hold. The key difference is,
when you put a call on hold you can only retrieve the held call from the phone
that put the call on hold. With Call Park, you can put a call on hold and pick it
up from ANY phone within the same Call Park Group. Through the Admin
Portal, Call Park Groups can be creates so specific groups of phones can
park calls for each other. If you do not create specific Call Park Groups, all
phones are automatically assigned to the Standard Call Park Group.
To create a Call Park Group which allows specific phone to park calls for each
other, login to the Admin Portal and click the Groups Tab then select Call Park
Groups.
To Park a Call:
1. While on a call, press the park soft key.
2. The phone will respond with a voice prompt such as "Call Parked on
9001". The caller will hear hold music.
3. To pick up the parked call, anyone on any phone may dial the park
number (9001 in this example) to be connected with the caller.

Paging (Intercom)

To page to all phones
Paging allows you to speak to all phones at the same time through their
speaker phone. If you pick up the handset during a page, you will hear the
message in the handset. Paging is used to make announcements such as
"Jim, you have a visitor in the lobby" or to let people know about a parked
call such as "Susan, you have a call waiting on Park 9001". Paging will only
notify phones not in use or not set to DND.
To group specific phones so only they receive specific Paging calls, login to the
Admin Portal and click the Groups Tab then select Paging Groups.
23