Ubiquiti AG-HP-5G27 Quick Start Manual page 11

Connect the power using one of the following options:
• Using the included Gigabit PoE Adapter: Go to
Connecting to the PoE Adapter.
• Using a separate PoE switch: Connect the Ethernet
cable from the device to a PoE‑enabled Ethernet port
on the switch.
WARNING:
power specifications listed in the Specifications
section of this Quick Start Guide.
Connecting to the PoE Adapter
1. Connect the Ethernet cable from the device to the POE
port of the PoE Adapter.
2. Connect an Ethernet cable from your LAN to the adapter's
LAN port.
3. Connect the Power Cord to the adapter's power port.
Connect the other end of the Power Cord to a power outlet.
Mounting the PoE Adapter (Optional)
1. Remove the PoE Mounting Bracket from the adapter, place
the bracket at the desired location, and mark the two holes.
2. Pre‑drill the holes if necessary, and secure the bracket
using two fasteners (not included).
3. Align the adapter's slots with the tabs of the PoE Mounting
Bracket, and then slide the adapter down.
The switch port must comply with the