Electric Handle Heating; Starting / Stopping The Engine - Stihl MS 441 C-M Instruction Manual

Electric Handle Heating

Switching on the handle heating system
(depending on equipment version)
Set switch to F – to switch off, return
N
switch to the 0 position
Overheating during continuous use is
impossible. The heating system is
maintenance-free.
MS 441 C-M
Starting / Stopping the
Engine
Positions of Master Control Lever
STOP
0
Stop 0 – engine off – the ignition is
switched off
Run position F – a hot engine is started
in this position or the engine runs in this
position
Start position } – a cold engine is
started in this position.
Setting the Master Control Lever
To move the Master Control lever from
the run position F to start }, depress
the trigger lockout and the throttle trigger
and hold them in that position – set the
Master Control lever to start } and let
go of the throttle trigger and trigger
lockout.
The Master Control lever moves from
the start position (}) to the run
position (F) when you press down the
throttle trigger lockout and squeeze the
throttle trigger at the same time.
Holding the Saw
There are two ways of holding the saw
when starting.
English
37