System Requirements - Gree SAP09HP230V1AO Installation Manual

SYSTEM REQUIREMENTS

PIPE SIZE in (mm)
Unit Size (ButH)
9,000
12,000
18,000
24,000
REFRIGERANT LINE LENGTHS ft (m)
Unit Size (ButH)
9,000
12,000
18,000
24,000
REFRIGERANT CHARGE
Unit Size (ButH)
9,000
12,000
18,000
24,000
ELECTRICAL REQUIREMENTS
Unit Size
(ButH)
9,000 208/230v - 1ph 60hz
12,000 208/230v - 1ph 60hz
18,000 208/230v - 1ph 60hz
24,000 208/230v - 1ph 60hz
*Main power wire from electrical panel to outdoor unit.
Notes: 1) System must be on a single dedicated circuit.
2) Power for indoor unit originates from outdoor unit.
3) Use table above for sizing of wiring and circuit breakers.
4) Follow all local building codes and NEC (National Electrical Code) regulations.
Interconnecting Cable: Recommended cable-14/4 A WG stranded bare copper conductors THHN 600V unshielded wire
Note: Use shielded cable if installation is in close proximity of RF and EMI transmitting devices.
Condensate Drain Size: 5/8-in OD 7/16-in ID
Min Line Length
10 (3)
10 (3)
10 (3)
10 (3)
Refrigerant Type
R410A
R410A
R410A
R410A
Min Circuit
Voltage
Amps (MCA)
Liquid Line
1/4 (6)
1/4 (6)
1/4 (6)
1/4 (6)
Pre-Charge
Max Line Length
Line Length
25 (7.5)
25 (7.5)
25 (7.5)
25 (7.5)
Factory System Charge
oz (kg)
45.9 (1.3)
49.4 (1.4)
74.1 (2.1)
81.1 (2.3)
Max Overcurrent
Protection (MOP)
9
9
22
22
Suction/Gas Line
1/2 (12)
1/2 (12)
5/8 (15)
5/8 (15)
Max Elevation
49 (15)
98 (30)
131 (40)
164 (50)
Additional Charge
oz/ft (g/m)
0.21 (20)
0.21 (20)
0.54 (50)
0.54 (50)
Main Power
Wire Size (AWG)*
15
15
30
35
33 (10)
49 (15)
66 (20)
98 (30)
12-2
12-2
10-2
10-2
5