Oki OKIPAGE 10ex Maintenance Manual page 163

• Engine maintenance mode menu system
LCD display
ENG MNT
LED HEAD
No. 17 *
Press the
MENU key.
HEADTYPE
TYPE 1*
Press the
MENU key.
OPT HEAD
600-4W*
Press the
MENU key.
STRB TIM
0.50*
Press the
MENU key.
SETTING
0 *
Press the
MENU key.
PRINTPOS
0 mm *
Press the
MENU key.
DRUM CNT
T nnnnnn
Press the
MENU key.
DRUM CNT
nnnnnn
Press the
MENU key.
T1 POS
0 mm*
Press the
MENU key.
No. 1
Press the
No. 4
or key.
.
No. 17 *
.
No. 27
No. 32
Press the
or key.
TYPE 1
TYPE 2D2
TYPE 2D4 *
Press the
or key.
300-1W
300-2W
600-4W *
Press the
0.54
or key.
0.50 *
0.46
0.42
Press the
0 *
or key.
+ 1
+ 2
- 1
- 2
Press the
or key.
0 mm *
+ 0.5 mm
.
+ 3.5 mm
- 4.0 mm
.
- 0.5 mm
0 mm *
Press the
+ 1 mm
or key.
:
+ 7 mm
- 8 mm
:
- 1 mm
D - 6
Writing into the EEPROM is performed after
pressing the ENTER key. Press the ON LINE key
if you wish to get out of this mode.
Please do re-set up the LED Head type to "Type2D4"
when the printer was done the engine reset operation
by manual or auto setting.
Because when it is done, the LED Head-type is re-
turned to the initial setting, which is "Type1".
* Application ROM (R/W ver.1.01)
8174627N0011(MX23C2410MC-10-100 : IC3)
8174627N0012(MX23C2410MC-10-101 : IC2)
Writing into the EEPROM is performed after
pressing the ENTER key.
Writing into the EEPROM is performed after
pressing the ENTER key.
PRINTPOS is for shipping. Do not change the
default setting.
Do not change the default setting.