Switch To Hub Or Switch - SignaMax 065-7930 User Manual

Signamax
The Link/Act LEDs for each UTP port light green when the link is
valid. The LED over the port label indicates a port speed of either
10/100 Mbps or 1000Mbps. A blinking LED on the bottom
indicates packet activity on that port.

Switch to Hub or Switch

These connections can be accomplished in a number of ways using
a Standard Ethernet patch cable.
•
A 10BaseT hub or switch can be connected to the Switch
via a twisted-pair Category 3, 4 or 5 UTP/STP cable.
•
A 100BaseTX hub or switch can be connected to the
Switch via a twisted -pair Category 5 UTP/STP cable.
•
A 1000BaseTX switch can be connected to the Switch via
a twisted -pair Category 5 (or better) UTP/STP cable.
Switch connected to a port on a hub or switch using either a
straight or crossover cable–any standard Ethernet cable is
fine
™
065-7930 16-Port Gigabit Ethernet Switch
25