Table of Contents
Advertisement
Signamax
Use caution when pressing the component rail release latches and
sliding a component into or out of a rack; the slide rails can pinch
your fingers.
After a component is inserted into the rack, carefully extend the rail
into a locking position, and then slide the component into the rack.
Do not overload the AC supply branch circuit that provides power
to the rack. The total rack load should not exceed 80 percent of the
branch circuit rating.
Ensure that proper airflow is provided to components in the rack.
Do not step on or stand on any component when servicing other
components in a rack.
™
065-7930 16-Port Gigabit Ethernet Switch
NOTE:
A qualified electrician must perform all
connections to DC power and to safety grounds. All
electrical wiring must comply with applicable local or
national codes and practices.
CAUTION: Never defeat the ground conductor or
operate the equipment in the absence of a suitably
installed ground conductor. Contact the appropriate
electrical inspection authority or an electrician if you
are uncertain that suitable grounding is available.
CAUTION: The system chassis must be positively
grounded to the rack cabinet frame. Do not attempt
to connect power to the system until grounding
cables are connected. Completed power and safety
ground wiring must be inspected by a qualified
electrical inspector. An energy hazard will exist if the
safety ground cable is omitted or disconnected.
xi
Advertisement
Table of Contents
