Table of Contents
Advertisement
Signamax
General Precautions for Rack-
Mountable Products
Observe the following precautions for rack stability and safety.
Also refer to the rack installation documentation accompanying the
system and the rack for specific caution statements and procedures.
Systems are considered to be components in a rack. Thus,
"component" refers to any system as well as to various peripherals
or supporting hardware.
•
Before working on the rack, make sure that the stabilizers
are secured to the rack, extended to the floor, and that the
full weight of the rack rests on the floor. Install front and
side stabilizers on a single rack or front stabilizers for
joined multiple racks before working on the rack.
Always load the rack from the bottom up, and load the heaviest
item in the rack first.
Make sure that the rack is level and stable before extending a
component from the rack.
™
065-7930 16-Port Gigabit Ethernet Switch
CAUTION: Installing systems in a rack without the
front and side stabilizers installed could cause the
rack to tip over, potentially resulting in bodily injury
under certain circumstances. Therefore, always
install the stabilizers before installing components in
the rack.
After installing system/components in a rack, never
pull more than one component out of the rack on its
slide assemblies at one time. The weight of more
than one extended component could cause the rack
to tip over and may result in serious injury.
x
Advertisement
Table of Contents
