Table of Contents
Advertisement
Signamax
Power
1000M
Link/Act
Rear Panel Description
The rear panel of the switch contains an AC power connector.
Rear panel view of the Switch
The AC power connector is a standard three-pronged connector that
supports the power cord. Plug-in the female connector of the
provided power cord into this socket, and the male side of the cord
into a power outlet. The switch automatically adjusts its power
setting to any supply voltage in the range from 100 ~ 240 VAC at
50 ~ 60 Hz.
™
065-7930 16-Port Gigabit Ethernet Switch
This indicator on the front panel should be lit
during the Power-On Self Test (POST). It will
light green approximately 2 seconds after the
switch is powered on to indicate the ready
state of the device.
This indicator on the front panel will light solid
green for a port transferring at 1000Mbps. If
this LED is dark, the port will be transferring
at 10/100Mbps
Each on-board Gigabit Ethernet port has a
corresponding indicator. This will light steady
green for a valid link and blink whenever there
is reception or transmission (i.e. Activity--Act)
of data occurring at a port.
19
Advertisement
Table of Contents
