Advertisement
5.
Lift the FL module out of the frame.
6.
Lift the end of the reflector sheet covering the white FL cable and lift out the FL.
Be careful not to pull or apply tension to the reflector sheet.
Installing the FL
To install the FL, follow the steps below and refer to Figures 4-52 and 4-51.
1.
Seat the FL, gently press it securely in place and cover the white FL cable
with the reflector sheet. Be careful not to pull or apply tension to the reflector
sheet.
2.
Secure four latches.
3.
Secure two M2x6 screws.
4.
Install the LCD module, FL inverter board, display mask, optional PC card,
optional memory module, and the battery pack as described in Sections 4.20,
4.18, 4.16, 4.4, 4.3, and 4.2.
200 Series
Figure 4-52 Removing the FL (DSTN)
4-53
Advertisement
