Advertisement
8.
Carefully rotate the two parts of the LCD PCB out so you can access the FL.
9.
Remove the white protective tape securing the FL.
10.
Pull back the white plastic cover and remove the FL. Be sure to note how the FL
is threaded.
NOTE: Be extremely careful of the silver covering over the screen itself - do
not remove this covering.
Installing the FL
To install the FL, follow the steps below and refer to Figure 4-50 and 4-49.
1.
Place the FL in the frame. Lift up the white plastic cover to route the FL cable.
2.
Replace the white protective tape covering the FL.
3.
Rotate the two parts of the LCD PCB (connected by a flexible cable) back into
place and press firmly to connect the LCD PCB to CN2 on the LCD module.
4.
Secure the LCD PCB with one M2x2.3 black screw, 2 M2x3.5 and 2 M2x5.5
silver screws.
5.
Seat the metal FL cover.
6.
Secure two latches.
7.
Secure two M2x3.5 silver screws.
8.
Replace the protective gold tape.
9.
Install the LCD module, FL inverter board, display mask, optional PC card,
optional memory module, and the battery pack as described in Sections 4.20,
4.18, 4.16, 4.4, 4.3, and 4.2.
200 Series
Figure 4-50 Removing the FL (TFT)
4-51
Advertisement
