Advertisement
(g)
System Beep
Use this feature to enable or disable the system beep.
(h)
Panel Power On/Off
Allows you to automatically turn your computer on or off by opening or
closing the display panel. If this feature is enabled when the computer is in
Resume mode, the system is automatically powered off when the display
panel is closed and powered on when the panel is opened. This option does
not appear when the computer is in boot mode.
NOTE: Do not remove the AC cable and battery pack at the same time
when you use this feature. If you do so, data saved by AutoResume will
be lost. You must also reset this option.
(i)
Alarm Power On
Lets you set the time for the system to turn on automatically. For example,
if you are expecting to receive a modem transmission at a time when you are
away or asleep, you can set this option to the time of the transmission. This
option does not automatically turn off the system. This feature operates in
either Resume or boot mode.
NOTE: Do not remove the AC cable and battery pack at the same time
when you use this feature. If you do so, the setting will be lost. You
must reset this option when you restore power.
3-66
ALARM VOLUME OPTIONS
Low BATTERY Alarm
Panel Close Alarm
Enabled
Enables the feature. (Default)
Disabled
Disables the feature.
Enabled
Enables the feature. (Default)
Disabled
Disables the feature.
Enabled
Enables the feature.
Disabled
Disables the feature. (Default)
00:00:00
Sets the power on time (24-hour clock).
Disabled
Disables the alarm.
=
Enabled
=
Enabled
200 Series
Advertisement
