Advertisement
4.9
Sub-Battery and VGA Board
Removing the Sub-Battery and VGA Board
To remove the sub-battery and VGA board, follow the steps below and refer to Figures 4-22
to 4-25.
1.
Turn off the power to the computer. Disconnect the AC power cord and all
external cables connected to the computer.
2.
Remove the battery pack, optional PC card, optional memory module, FDD or
CD-ROM drive, HDD, and keyboard as described in Sections 4.2 through 4.8.
3.
Disconnect the sub-battery cable from PJ503. Press down on the battery holder
to remove the battery.
NOTE: The battery is held in place with a sticky backing, carefully pry the
battery away from the battery holder.
WARNING: If you replace the sub-battery, be sure to use only batteries
recommended by Toshiba. Installation of the wrong battery can cause the
battery to explode or otherwise cause damage.
200 Series
Figure 4-22 Removing the sub-battery
4-23
Advertisement
