Advertisement
4.
Carefully rotate the LCD module out of the LCD cover and lay it on the
keyboard.
5.
Disconnect the flexible display cable from the display unit and disconnect four
display cables from PJ2, PJ3, PJ4, and PJ5 on the flexible cable.
6.
Remove the shielded tape securing the display cables to the LCD cover.
Installing the LCD Module
To install the LCD module, follow the steps below and refer to Figures 4-46 and 4-45.
1.
Secure the display cable to the LCD cover with shielded tape.
2.
Connect the display cables to PJ2, PJ3, PJ4, and PJ5 on the flexible cable and
connect the flexible cable to the LCD module.
3.
Carefully rotate the LCD module into the LCD cover. Be sure the flexible cable
fits securely into the clear plastic protector.
NOTE: Support the back of the display with your hand when you secure the
screws.
4.
Secure four M2.5x6 screws on the LCD module. Make sure the ground cable is
secured at the lower left corner.
5.
Install the FL inverter board, display mask, optional memory module, optional PC
card, and battery pack as described in Sections 4.17, 4.16, 4.4, 4.3, and 4.2.
200 Series
Figure 4-46 Removing the LCD module (TFT)
4-47
Advertisement
