Advertisement
NOTE: Some memory modules have a plastic tab. If so, simply pull up on the
tab to disengage the connector.
Installing an Optional Memory Module
To install an optional memory module, make sure the computer is in boot mode then follow
the steps below and refer to Figures 4-8 back through 4-6.
1.
Position the connector on the bottom of the module over the corresponding
connector on the computer (align the holes on the side of the module over the
screw holes on the brace).
NOTE: Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access problems.
2.
Place your fingers above the connector and press firmly but gently to assure a
solid connection. The module should be seated level.
3.
Secure the module to the brace with two silver M2x4 screws.
4.
Lay the cover in place. If the memory module has a plastic tab, fold it down first
then place the cover.
5.
Secure the cover with two silver M2x4 screws.
6.
Install the battery pack and optional PC card as described in Sections 4.3 and 4.2.
200 Series
Figure 4-8 Installing the memory module
4-11
Advertisement
