Makita JS1660 Instruction Manual page 7

1. Limit mark
1
2
1. Screwdriver
2. Brush holder cap
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Hex wrench
For JS1670
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
004706
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
Max. cutting capacities
2
Steel up to 400 N/mm
Steel up to 600 N/mm 2
2
Steel up to 800 N/mm
2
Aluminum up to 200 N/mm
• Wrench holder
006434
mm ga
1.0 20
0.7 23
0.5 26
2.5 13
7